7 / 72
Horizontal End Suction Pump for Chemical Process, ASME B73.1-2001
Installation, Operation, and Maintenance Manual – CPP21
SECTION TWO - SAFETY
This operation manual gives basic instructions that should be observed during installation, operation and
maintenance of the pump. It is therefore imperative that this manual be read by the responsible
personnel/operator prior to assembly and commissioning. It must always be kept available at the installation
site. Not only are the general safety instructions contained under this
SECTION TWO - SAFETY that must be
observed but also the specific information provided in other sections.
2.1 IDENTIFICATION OF SAFETY INSTRUCTIONS IN THE OPERATING MANUAL
Safety instructions given in this manual whose non-compliance would affect personal and equipment safety are
identified by the following symbol.
Where electrical safety is involved, the following symbol is shown.
The symbol is inserted in safety instructions whenever non-compliance might endanger the
machine or its function.
It is imperative that signs affixed to the machine are observed and kept legible, for example:
• arrow indicating the direction of rotation
• symbols indicating fluid connections
2.2 QUALIFICATION AND TRAINING OF OPERATING PERSONNEL
The personnel responsible for operation, maintenance, inspection and assembly must be adequately qualified.
The responsibilities and supervision of the personnel must be exactly defined by the plant operator. If the staff
does not have the necessary knowledge, they must be trained and instructed. Training may be performed by a
Ruhrpumpen representative on behalf of the plant operator. Moreover, the plant operator is to make sure that
To Next Page
Loading...