9 / 72
Horizontal End Suction Pump for Chemical Process, ASME B73.1-2001
Installation, Operation, and Maintenance Manual – CPP21
performed by authorized and qualified personnel who have adequately familiarized themselves with the subject
in matter by studying this manual in detail.
Any work on the machine shall only be performed when it is at a standstill. To shut off the machine it is
imperative to follow the procedure for shutting down the machine as described in
SECTION 7.5-STOPPING.
Pumps and pump units that convey hazardous materials must be decontaminated before any maintenance work
is performed.
On completion of work all safety and protective facilities must be re-installed and made operative again.
Prior to restarting the machine, follow the instructions listed under
SECTION 7.2-STARTUP.
2.7 UNAUTHORIZED ALTERATIONS AND SPARE PARTS
Modifications may be made to the machine only after consultation with a Ruhrpumpen representative.
Using spare parts and accessories authorized by Ruhrpumpen is in the interest of safety. The use of parts not
authorized by the dealer exempt the manufacturer from any liability, voiding the warranty.
2.8 UNAUTHORIZED MODES OF OPERATION
The reliability of the machine is guaranteed if and only if it is used in the intended manner, in accordance with
the statutes of this manual. The limit values specified in the data sheet must never be exceeded under any
circumstance.
To Next Page
Loading...