Web-based Configuration Guide Login
3
Note
Under normal circumstances, when multiple new devices are powered on and connected, they will be
automatically interconnected into a network, and the user only needs to confirm that the number of devices is
correct.
If there are other devices in the network that are not added to the current network, you can click Add to My
Network and enter the management password of the added device to manually add the corresponding device
to the network where the device is located, and then start the network-wide configuration.
2. Creating a Web Project
Click Start Setup to set the networking modes and management password of the device.
(1) Network Name: Identify the network where the device is located.
(2) Internet: Select the networking mode.
○ DHCP: An IP address is assigned to the device by the uplink DHCP server. By default, the device detects
whether the IP address can be dynamically obtained. If the IP address is obtained successfully, there is
no need to manually set the IP address.
○ Static IP: The user manually enter a specified IP address, subnet mask, gateway IP address, and DNS
address.
(3) Management Password: Set the password for logging in to the management page.
(4) Country/Region: Select the country or region where the device is located.
(5) Time Zone: Set the system time. The network time server is enabled to provide time services by default.
Please select your actual time zone.
To Next Page
Loading...
Need help?
General