RUPTELA FM-Plug4 - Device Preparation; Opening the Device Housing

To Next Page

To Previous Page

4 Device Preparation

For the device to work, you first need to insert a SIM card. To do so, open the device housing and

perform the actions described below.

4.1 Opening the Device

Use a flat head screwdriver to open the plastic housing. Insert the screwdriver between the top and

bottom parts of the housing and lift the top part up as shown in the image below. The top of the

housing should easily dismount from the holding pins.

Make sure that the device is powered off before opening it!

The use of inappropriate tools or excessive force may cause permanent damage to the

device.

Avoid opening the device more times than required, as it may wear out the holding pins.