EN
8
Approach the horns and position them forward-facing in front according to Fig. 6.
Fig. 6
Installation of the protection device
Install the protection at the fixing points and tighten the 4 screws firmly.
This has the role of protecting the user from hard bodies that can bounce during use as
well as as the role of load limiter.
Careful! Do not use the DAC bruscutter without the protective device .
Mounting-disassembly of the cutter disk and autocut
To proceed properly you will need to have the following necessary tools at hand: imbued-
blocker and the wrench of the brushcutter equipment.
The order of assembly-disassembly is presented in Fig. 7
To Next Page
Loading...
