Ruris DAC 310 - Equipment Storage; Maintenance Table

EN
22
10.1.1 MAINTENANCE TABLE
Device and execution
Term of execution of the maintenance operation
Terms
During run-in
In the post-run-in period
Dipositive
Execution
At 3
hours
Before
each
start of
work
25
50
100
Minim
data
per
year
Machine
Carburetor
settings
y
Air filter
Cleaning
x
Spark
Cleaning,
Control
x
Replacement
x
x
Cooling
Clean
x
Carburetor
Clean if need
y
y
Fuel
mixture
Replacement
At 7 days
gear
(reducer)
Vaseline
exchange or
filling
x
x
Gas filter
Replacement
At 25 hours
x-user
y-service authorized
11. EQUIPMENT STORAGE.
If you don't use the brush cutter longer (over a dighand) do as follows:
● Clean the brush cutter.
● Empty the fuel from the tank.
● Turn on the brush cutter and let it run until the fuel in the carburetor is consumed
and the brush cutter stops. This operation is necessary to prevent the
evaporation of gasoline from the mixture which can cause the carburetor orifice
to clog by depositing the remaining oil.
● Store in a dry place where children cannot reach.
● Store the brush cutter in a dry place, with a roof, where there is no moisture.
● Grease all active metal parts with Vaseline.
● Do not store the brush cutter near flammable areas or near exits.
The movement of the brush cutter over short or long distances is done only with the
engine stopped.