From the component :
Probes of the tester should be applied on to the relate
d connectors as shown on the
pictures
Water inlet valve:
From the electronical card:
Above sketch show the connectors of the water inlet valve
on the electronical card.
Probes of the tester should be applied on to the related connectors.
From the components :
Probes of the tester should be applied on to the related
connectors as shown on the pictures
CN2.6 – CN 2.9 3750 Ω
± 10 ( 20 Cº)
ELECTRONİCAL CARD
CONNECTOR
BLUE
PURPLE
CONNECTORS SHOULD BE MEASURED
56
To Next Page
Loading...
