Saab 9-4X Owner Manual - 2011
Instruments and Controls 5-7
See the infotainment system manual
for the location of the vehicle's
antenna. The compass system is
designed to operate for a certain
number of miles or degrees of turn
before needing a signal from the
GPS satellites. When the compass
display shows CAL, drive the
vehicle for a short distance in an
open area where it can receive a
GPS signal. The compass system
will automatically determine when a
GPS signal is restored and provide
a heading again. See Compass
Messages on page 5‑35 for more
information on the messages that
may be displayed for the compass.
Clock (Digital Clock)
The infotainment system controls
are used to access the time and
date settings through the menu
system. See the separate
infotainment system manual for
information about how to use the
menu system or how to operate
the digital clock for the navigation
system.
To turn the digital clock on or off:
1. Press the CONFIG button.
2. Select Time and Date Settings.
3. Select Clock Displayed.
4. Press MENU/SELECT to turn
the clock on or off.
Setting the Time and Date
1. Press the CONFIG button.
2. Select Time and Date Settings.
3. Select Set Time or Set Date.
4. Turn the MENU/SELECT knob to
adjust the highlighted value.
5. Press the MENU/SELECT knob
to select the next value.
6. To save the time or date
and return to the Time and
Date Settings menu, press
the
} BACK button at any time
or press the MENU/SELECT
knob after adjusting the minutes
or year.
To Next Page
Loading...
