Saab 9-4X 2011 - Headlamp Aiming

Black plate (34,1)
Saab 9-4X Owner Manual - 2011
10-34 Vehicle Care
2. Push the release lever (B) to
disengage the hook and push
the wiper arm (A) out of the
blade assembly (C).
3. Push the new blade assembly
securely on the wiper arm until
the release lever clicks into
place.
4. Replace the wiper cover.
Headlamp Aiming
The headlamp aiming system has
been preset at the factory.
If the vehicle is damaged in an
accident, the aim of the headlamps
can be affected and adjustment
could be necessary.
It is recommended that a dealer
adjust the headlamps. To re-aim the
headlamps yourself, use the
following procedure.
The vehicle should be properly
prepared as follows:
.
The vehicle should be placed so
the headlamps are 7.6 m (25 ft)
from a light colored wall.
.
The vehicle must have all four
tires on a level surface which is
level all the way to the wall.
.
The vehicle should be placed so
it is perpendicular to the wall or
other flat surface.
.
The vehicle should not have any
snow, ice, or mud on it.
.
The vehicle should be fully
assembled and all other work
stopped while headlamp aiming
is being performed.