Safeline MX2 - Page 18

18
SafeLine MX2 v.5.2.1 EN
Other codes Code Data Comments
Alarm button type *89* - # 0 = Normally-open contact, NO (Default)
1 = Normally-closed contact, NC
Change password *91* - - - - # Change password (default=0000)
Simulate an alarm event *94* - # Triggers an alarm event after programming is terminated.
1 = Emergency call
2 = Test alarm
3 = Battery failure
4 = Microphone/Loudspeaker failure
5 = Receipt on voice call
6 = Maintenance
7 = Main unit power failure
8 = Stuck button alarm
Reset to default settings *99* - # 1 = Factory default
2 = Default P100(The following codes will be set):
*21*0#, *22*0#, * 27*03#, *80*1#, *84*1#, *88*1#
3 = Default CPC(The following codes will be set):
*21*3#, *22*3#, *27*03#, *80*1#, *84*1#, *88*1#
4 = Default VOICE(The following codes will be set):
*21*1#, *22*1#, * 27*03#, *80*1#, *84*1#, *88*1#
Compatability mode *77* - # 0 = Automatic voice switching
The call is validated when there is a voice response. The
call is terminated by pressing ”#”.
1=KoneECII(lifttelephone)
When there is a voice response, some ascending tones
will be heard. The call is validated by pressing ”4”. The
call is terminated by pressing ”0”. The call is terminated
without reciept notication by pressing ”2”(the unit will
call the next number).
2 = Manual voice switching
When there is a voice response, some ascending tones
will be heard. The call is validated by pressing ”4”. Unit is
still in automatic mode.
To enter manual mode and talk press ”*”.
To listen press ”7”.
Go back to automatic mode press ”4”.
The call is terminated by pressing ”#”.
It is possible to enter manual voice switching mode
although the unit is programmed as automatic by pres-
sing ”*”. No ascending tones will be heard. For repeating
the voice message, press “1” in all modes.