EasyManua.ls Logo

Safeline MX3 - Page 13

Safeline MX3
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
© 2015 SafeLine and all the SafeLine products and accessories are copyrighted by law.
MX3 v1.06 EN
Configuration
Activate with DTMF 8 (Output 1, Configuration code 1)
The output is activated at the following events:
- DTMF tone 8 is received.
The output is deactivated at the following events:
- 3 seconds after activation.
Activate with DTMF 9 (Output 2, Configuration code 1)
The output is activated at the following events:
- DTMF tone 9 is received.
The output is deactivated at the following events:
- 3 seconds after activation.
System Failure (Output 1 & 2, Configuration code 2)
The output is activated at the following events:
- Telephone line OK.
The output is deactivated at the following events:
- Telephone line missing.
Emergency Bell (Output 1 & 2, Configuration code 3)
The output is activated at the following events:
- Emergency alarm button input active.
- The call is not yet connected.
The output is deactivated at the following events:
- Emergency alarm button input deactivated.
- The call is connected.
Silence Disconnect
The function will automatically disconnect a call if no sound is received from the alarm operator within a
set time. Only works for voice calls, not for P100/CPC/Q23.
The configuration is performed via SafeLine Pro or with the configuration code *92*X#, where X specifies
the time:
0 = The function is off.
1 = 30 seconds.
2 = 60 seconds (default).
3 = 90 seconds.
Software controlled volume control
The speaker volume is adjusted via the keyboard control. Key 2 raises and Key 8 lowers the volume in
6 steps. The volume can also be adjusted using the command *76*X# where X is the desired volume
position between 1 and 6. Default value is 3.
The set volume mode are stored in the EEPROM so that the unit remembers the set position.
External Mic / speaker part
When a call is activated by the emergency alarm button on the external mic/speaker part, the microphone
on the external mic/speaker part will be used and the internal microphone disconnected.
The speaker sound will however be heard from both speakers simultaneously.

Related product manuals