Safeline MX3 - Configuration Examples - Safeline Autodialer Units

16
© 2015 SafeLine and all the SafeLine products and accessories are copyrighted by law.
MX3 v1.06 EN
Confi guration
CONFIGURATION EXAMPLES - SAFELINE AUTODIALER UNITS
Lift ID code (each lift must have its own unique code).
1. Start confi guration:
2. 1
st
phone number :
3. 2
nd
phone number :
4. Call type 1
st
number :
5. Call type 2
st
number :
6. Alarm button delay:
7. End confi guration:
- Shown set for 3 seconds.
Note! Please refer to the full confi guration setup in the “Parameter list” as these are merely examples.
Example 1. Storing of two different telephone numbers, both to be answered as voice calls.
For test facility, see example 2.
Example 2. SLCC and 3 day test. (SLCC – SafeLine Call Centre)
If at any time you need to start over, use the factory reset command *99*1#.
(Only if using SLCC)
- Shown set for 3 days.
(For P100 use telephone number of SLCC, for Caller ID set
*31*4# and telephone number of GSM modem)
Enter P100 ID code:
2.
7. End confi guration:
6. Test alarm:
5. LMS phone number:
4.
Set number of days between
test alarm:
3. Set test alarm type:
1. Start confi guration:
If at any time you need to start over, use the factory reset command *99*1#.
- Shown set for: voice.
- Shown set for: voice.
- Shown set for: P100.