Safetytest 1ST - Measurements; Functional Test; Documentation of the Test

SAFETYTEST 1ST User Manual SAFETY
TEST
SAFETYTEST GmbH June 15
th
2015 Page 13 of 22
10.4 Measurements
See menu system
10.5 Functional Test
After performing the electrical test a functional test is required. A short test may be sufficient.
10.6 Checking the Markings
The presence of safety required markings must be checked and if necessary renewed or
completed.
10.7 Documentation of the test
The passed test has to be documented. If an appliance is unsafe, this must be marked clearly
on the appliance and the responsible body to be notified in writing. The measurement values
and alterations performed are to be documented. The appliance should be marked by a
sticker that for example states the following: “Tested according to VDE 0701-0702 and DGUV
Standards 3” .