Safetytest 1ST - General Safety and Warning Notes

SAFETYTEST 1ST User Manual SAFETY
TEST
SAFETYTEST GmbH June 15
th
2015 Page 5 of 22
1 General Safety and Warning Notes
The tester “Safetytest 1ST” was built and complies with the following safety standards.
DIN EN 61010-1 (VDE 0411 part 1),
SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR
MEASUREMENT, CONTROL, AND LABORATORY USE
DIN VDE 0404 parts 1 and 2,
“Geräte zum Prüfen, Messen oder Überwachen von Schutzmaßnahmen“
Immunity according to DIN EN 61326,
“Elektrische Betriebsmittel für Leittechnik und Laboreinsatz - EMV-Anforderungen“
In order to warrant the safe application of the tester the following warnings have to be
adhered to:
All tests may only be carried out by a skilled electrician or under
the supervision of a skilled electrician. The qualified person must
be trained for the specific task.
The tester subject only to its intended use. The warning markings
on the tester, the connecting cables and accessories have to be
observed.
The tester may be used only on 230V AC main systems which are
protected with max 16A circuit breakers or fuses.
Measurements may not be performed on unfused circuits.
Repairs and alterations to the tester may be carried out only by the
manufacturer or by a service organization qualified by the
manufacturer. Repairs on the supply leads or adapter cables may
be carried out only by skilled electricians.
Only original spare parts supplied by the manufacturer may be
used.
Fuses may be replaced only by the original fuses of the
manufacturer.
If a safe application is not possible, e. g. due to:
- Visual defects,
- Improper storage,
- Improper transport,
- Failure of a phase control lamp,
- Failure of measurement functions,
the tester must be decommissioned! Repair may be done only by
the manufacturer or a service organization authorised by the
manufacturer.