EasyManua.ls Logo

Safetytest 1ST - Page 22

Safetytest 1ST
22 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETYTEST 1ST User Manual
SAFETY
TEST
SAFETYTEST GmbH June 15
th
2015 Page 22 of 22
Phase voltage: 0,0V...440,0V
Phase current: 0,00A ... 20,00 A
Power: 0W ... 4 kW. Evaluation up to the 15th harmonic.
Power standby (option): 0,000W…9,999W, Current max. 50 mA
PE monitor: Voltage N-PE> 30V.
Integrated leakage current power off: Differential current > approx. 20 mA.
Clamp measurement:
Ratio 2000:1
Differential current 0,00 … 20,00 mA
Line current: 0…40,00 A
RCD (optional): 10 mA, 30 mA, 100mA, 300mA, 500mA tripping current and time
Open circuit voltage Welding current circuit with electronic potentiometer: 0 … 150V
Test sequences:
Standard EN 62638/EN 62353
Class I active / passive (Powered / without mains)
Class II
Class III
Fixed connection
Extension lead
Single measurements
Interface:
RS232 for PC, Barcodereader and printer.
USB Type A for PC,Can be remote controlled.
USB Type A for memory stick and HID connector
Memory, Real time clock:
approx. 100000 measurement sequences with time and date.
16 Disposal
The disposal of a decommissioned tester must be carried out by the customer according to
the national regulations.
17 Guarantee
The tester “SAFETYTEST 1ST” is subject to a strict quality assurance system.
A calibration certificate with the documentation of the test results is delivered together with
the tester.
This certificate should always be available.
The guarantee period is for 12 months after delivery. Manufacturing defects and material
defects are covered by the guarantee.
Transport costs to the manufacturer are born by the sender. For normal transports within
Germany to the customer the manufacturer pays. Special transport costs, e. g. express
delivery have to be borne by the customer.
Transport and costs for use of substitute equipment must be carried by the customer.
Damages due to dropping or improper use are exempted from the guarantee as well as parts
underlying wear and tear like sockets, plugs, fuses, batteries, mechanical parts.
If defects occur after the guarantee period, the service department will repair the articles
quickly.

Table of Contents