3 - Installation in Microsoft Windows
SAGEM F@st™ 800 / 840 (PPP) User Guide - 288 047 975-03
Page 3-2 Sagem Communication document. Reproduction and disclosure prohibited
The procedures for installing, checking installation and uninstalling described
below have been carried out arbitrarily using Windows
XP. There may be slight
differences when installing in other Windows operating systems (98SE, ME and
2000).
3.1 Installing the SAGEM F@st
TM
800 / 840
1
Insert the CD-ROM in the appropriate
drive on your computer; the screen
opposite appears.
Click "Install the modem".
Note: If this screen does not appear, from the Start menu, select Run, and then enter:
"<CD-ROM drive letter> :\autorun.exe (for example e:\autorun.exe)
then click OK.
This allows your computer to run installation.
2
After the files have been copied to the
hard disk in your computer, the
following screen appears.
Connect the USB cable to the
SAGEM F@st
TM
800 / 840 modem via
the USB connector on the rear panel.
3
Windows then proceeds to install the various software components. Please wait until an
end-of-installation message appears or until Windows prompts you to restart your
computer.
Note: After connecting the modem, in Windows
98 SE, the operating system may
ask for the Windows installation CD-ROM. If so, insert this CD-ROM to
continue installation.
To Next Page
Loading...
General