DIGITAL TERMINAL USER MANUAL
19
10. SOFTWARE UPDATE
The decoder software can be updated over the air.
When a new software version is available, the decoder automatically proposes an update.
1
Press "OK" to start the update (recommended). Your decoder will then be unavailable for a few minutes.
During this period, the TV screen is black and the front panel display shows a scrolling "00 - -", "01 - - ",
"02 - -", "03 - -", "04 - -", indicating that updating is in progress.
If a problem occurs during the update, the decoder stops and displays an error message on the front panel
2
.
Pressing any key on the remote control will abort the update process and return the decoder to normal use.
1 The update prompt appears when you exit standby. So that you can take advantage of this important function, we
recommend that you set your decoder to standby when not in use.
2 Refer to appendix A for the list of errors.
DOWNLOAD
PROCESS
In order to improve the set top box
functionnalities, a software
download is necessary.
During the download, the screen
will be black.
Do not switch off your box during
this time.
To receive the update
press OK otherwise cancel
CONFIRMCANCEL
LU 252744938B ITD81 HD EN.book Page 19 Mercredi, 7. juin 2006 6:31 18
To Next Page
Loading...
Need help?
General
