SAGEMCOM C112 ECO User Manual

11
INITIAL INSTALLATION
GETTING STARTED WITH THE TELEPHONE
• Click the spiral cord of the telephone set into its socket (1) on
the base side.
• Click the end of the line cord into its socket (2) and plug the
other end into the wall socket (3).
The telephone display will come on 1 minute after connection
and you can use your phone in the normal way.
Adjustments to make before use
After installing your telephone, adjust the time and the contrast
(if necessary). It is important to make these adjustments before
using your telephone.
Refer to paragraph "Modifying the flash duration (Key «R») ",
page 26, to set the flash duration.
Refer to paragraph "Modifying the date and time ", page 24, to
set the date and time of the telephone.
If you cannot see the screen display, refer to paragraph
"Adjusting the contrast ", page 25.
The C112 ECO / C130 ECO telephone is designed
to be connect to a SINGLE telephone line before use.
Before making any connections, please refer to the
paragraph "Recommendations and safety
instructions", page 4
The C112 ECO / C130 ECO is self-powered,
needing no batteries and just 1 minute of connection
to the telephone socket before use.
3
2
1

SAGEMCOM C112 ECO Specifications

General

Brand	SAGEMCOM
Model	C112 ECO
Category	Telephone
Language	English