- 15 -
- HDMI OUTPUT
*
:select YES to active the output.
-
HDMI RESOLUTION
*
: select the resolution (576i, 576p, 720p 720p or 1080i depending on the
resolutions offer on your television set) for the HDMI output
.
7-4-4 Audio settings
In the RECEIVER SETTINGS menu, select AUDIO SETTINGS.
Navigate using the arrows then confirm your choices with . Refer to the instruction manual of your
audio equipment for more details about the audio configuration of the equipment.
- DIGITAL AUDIO OUTPUT: select the type of audio data for the DIGITAL AUDIO digital output: Stereo
or Home Cinema.
If you choose "HOME CINEMA", when a programme with audio signal of type AC3 is broadcasted, the
signal is directly transmitted to your amplifier. Otherwise, it is the main audio signal that is transmitted to
the amplifier.
Because the audio volume may vary from one programme/channel to another (due to the type of signal
received, PCM or AC3), you can adjust the audio volume output on the home cinema to reduce volume
differences between programmes/channels: to do so, select the adjustment setting then use the and
keys to increase or decrease the volume.
7-4-5 Return to default factory settings
In the RECEIVER SETTINGS menu, select RESET FACTORY DEFAULT.
This function enables you to restore the default settings of the receiver.
To cancel the operation, press or .
If you wish to reinitialise the receiver, press .
Once the initial configuration is restored, the installation screen of the receiver is displayed. You can then
reconfigure your receiver (see “First installation”, page 10).
*. Model DTR6700T only.
At the first installation, the receiver offers by default the best resolution to
obtain the best video quality on HDMI output.
Select "HOME CINEMA" mode only if you have connected an amplifier sup-
porting this mode.
All the channels and parameters will be lost if you confirm this choice, but the
recordings will not be erased.
DTR67_ EN.book Page 15 Mardi, 20. avril 2010 2:46 14
To Next Page
Loading...
Need help?
General
