SAGEMCOM UM20 User Manual

1-Free Sagemcom - Modification with the authorization of the management concerned – This docu-
ment and the information it contains is the property of Sagemcom
3000499643-R11-000-01
Page 9
UM User Manual (EN) rev. 3.2
CAUTION: This equipment may not be modified, altered, or changed in any way without signed written
permission from Sagemcom USA. Unauthorized modification may void the equipment authorization
from the FCC and will void the Sagemcom USA warranty.
This device complies with FCC RF radiation exposure limits set forth for general population (uncontrolled
exposure). This device must be installed to provide a separation distance of at least 31 cm (1 ft) from
all persons and must not be collocated or operating in conjunction with any other antenna or transmitter.
FCC Responsible Party:
Sagemcom USA
14651 N. Dallas Parkway Suite 900
Dallas, TX 75254
Phone: 972-674-4100
FCC Radiation Exposure Statement
This device produces radio frequency energy in the 3GPP band 4 (1710 to 1755 MHz), band 13 (777
to 787 MHz) and 2.4GHz spectrum. The antenna must be positioned to keep a minimum distance of
31 cm (1 ft) from the radiating element to any nearby person.
Innovation, Science and Economic Development Canada “ISED”
WARNING TO USERS IN THE CANADA
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
This device complies with Industry Canada RF radiation exposure limits set forth for general population
(uncontrolled exposure). This device must be installed to provide a separation distance of at least 31cm
from all persons and must not be collocated or operating in conjunction with any other antenna or trans-
mitter.
This device has been designed to operate with the antenna(s) listed below, and having a maximum gain
of +3 dBi. Antennas not included in this list or having a gain greater than +3 dBi are strictly prohibited
for use with this device. The required antenna impedance is 50 Ω.
List of acceptable antenna(s):
- 1GH-06SA-A
UL certification
This product is certified by UL. Representative samples of this product have been
evaluated by UL and meet applicable standards.

SAGEMCOM UM20 Specifications

General

Brand	SAGEMCOM
Model	UM20
Category	Measuring Instruments
Language	English