Saimo 6101 - Page 100

To Next Page

To Previous Page

6101

6101 Belt

Belt

Belt Scale

Scale

Scale Integrator

Integrator

Integrator Operating

Operating

Operating and

and

and Service

Service

Service Manual

Manual

4.3.5

4.3.5 Constant

Constant

Constant Setup

Setup

For the integrator which is newly put into service or just replaced the battery module, the

constant should be input according to the initial calibration.

· Power the integrator on

· Input belt speed (establish test duration in calibration menu, the belt must have been

running for over 30 minutes with no load.)

· I nput other constants (zero, span, scale capacity, etc)

4.4

4.4 Usual

Usual

Usual Troubleshooting

Troubleshooting

W hen the material is smoothly delivered but the flowrate indication in integrator varies

greatly, there may be various reasons such as: broken load cell, damaged speed sensor, bad

integrator, defective mechanical construction, signal interference, etc. The former three

factors have been mentioned hereinbefore.

The defective mechanical structure on the site mainly contains: inactive trunnion (adjust the

trunnion screw to improve), loose pull bar (fasten the set nut to improve), material blockage

(clear off material to improve). Eliminate any potential problems perceptible. Signal

interference is mainly caused by electromagnetic field . The preventative measures is to route

the signal cable separate from power cable far away, and ensure that the integrator is

grounded well (comply with the grounding specification).