Saimo 6101 - Safety Precautions

6101
6101
6101
6101 Belt
Belt
Belt
Belt Scale
Scale
Scale
Scale Integrator
Integrator
Integrator
Integrator Operating
Operating
Operating
Operating and
and
and
and Service
Service
Service
Service Manual
Manual
Manual
Manual
18
Figure 2- 4 6101 Panel mounting integrator outline dimension and mounting dimension
Note:
1. See figure 2-4 for Panel mounting dimensions.
2. Take fixing bracket clamp out from the package when installation.
3. Remove bracket clamp and push housing in from the front of opening hole, then mount
bracket clamp and fasten the bolt accordingly.
2.2.2
2.2.2
2.2.2
2.2.2 Safety
Safety
Safety
Safety Precautions
Precautions
Precautions
Precautions
Dangerous
Dangerous
Dangerous
Dangerous !
!
!
!
Do not install, operate, or perform any maintenance procedures until you have read the
safety precautions which follow.
1. Do not connect power to the electronics or turn on the unit until you have read and
understood this entire manual. The precautions and procedures presented in this manual
must be followed carefully in order to prevent equipment damage and protect the
operator from possible injury.
2. CAUTION
Hands and clothing must be kept away from all moving or rotating parts.
3. WARNING
Covers over the electronics should always remain in place during operation. They should
be removed only fro maintenance procedures with the machine ’ s power OFF. Be sure to
replace all covers before resuming operation.
4. WARNING
All switches (such as control or power) must be OFF when checking input AC electrical
connections, removing or inserting printed circuit boards, or attaching voltmeters to the
system.
5. Incoming voltages must be checked with a voltmeter before being connected to the
electronics.
6. WARNING
Extreme caution must be used in testing in, on, or around the electronics, PC boards, or
modules. There are voltages in excess of 115V or 230V in these areas. Avoid high
voltage and static electricity around the printed circuit boards.
7. Maintenance procedures should be performed only by qualified service personnel and in