Saimo 6105 - Material Calibration

6105
6105
6105
6105 Belt
Belt
Belt
Belt Feeder
Feeder
Feeder
Feeder integrator
integrator
integrator
integrator ---
---
---
--- User
User
User
User ’
’
’
’ s
s
s
s Guide
Guide
Guide
Guide ---
---
---
---
27
When the automatic span calibration is finished, the screen returns to the first menu of Auto Span.
b. Manual Spanning
If p res s “ MANL SPAN ” soft key from the Span Calibration Menu mentioned in section 5.3.2.2, the
Manual Spanning screen appears:
Press numeric keys to enter the new span and press “ SURE SPAN ” to validate it.
5.3.2.3
5.3.2.3
5.3.2.3
5.3.2.3 Material
Material
Material
Material Calibration
Calibration
Calibration
Calibration
Material Calibration menu is accessible by selecting “ 2.3 ZERO CALIBRATION ” from the Calibration
Menu as shown in section 5.3.2.
2006-3-21 12:00:00 Scale #1
8 000000 t
888 t/h
1m/s
Belt stops, Cal stop !
BGIN EXIT
CAL CAL
2006-3-21 12:00:00 Scale #1
8 000000 t
Old span:[ 888 ]
New span:
Manual span mode!
Input span:
BGIN EXIT SURE
CAL CAL SPAN