Note: It is recommended to plug in the power adapter to
reduce the battery consumption and extend the service life
2. Display Console Batteries Installation
Remove the battery door on the back of the display, as shown
in Figure 7. Install three AAA (alkaline or lithium)) batteries.
The display will beep once and layout of display will light up for
a few seconds to verify all segments are operating properly.
Figure 7
Recover the battery door, and unfold out the desk stand to
place the console in the upright position
Note: The battery is a back-up of weather station console,
saving console settings when powered off from adaptor
To Next Page
Loading...
