SAJ eSolar RS485 - Inverter Export Limitation Settings; APP Export Limitation Configuration

- 14 -
③
Press “▲” / “▼”to change the value of “P-Limit”, after a certain value
settled, press “ENT”to move the cursor point to the last number, press
“ENT”again then the settings complete.
E.g.: When Sununo Plus 1K is used, if set the“P-Limit” valueinto 1000W,
the Max. power fed into the grid is 1000W.
3.2.2 APP Configuration
① Login APP and connect the module WiFi.
② Enter “Remote control” interface to select “Mode setting” → turn on the
“Export limitation” (it is off by default) as showed in Figure 3-12.
Figure 3-11 Figure 3-12 Figure 3-13