PREPARATION
2.1 Safety Instructions
For safety, be sure to read all the safety instructions carefully prior to any works, and please observe the
appropriate rules and regulations of the country or region where you installed the energy storage system.
· There is possibility of dying due to electrical shock and high voltage.
· Do not touch the operating component of the inverter; it might result in burning or death.
· To prevent risk of electric shock during installation and maintenance, please make sure that all AC and DC terminals
are plugged out.
· Do not touch the surface of the equipment while the housing is wet, otherwise, it might cause electrical shock.
· Do not stay close to the equipment while there are severe weather conditions including storm, lighting, etc.
· Before opening the housing, the SAJ inverter must be disconnected from the grid and PV generator; you must wait
for at least five minutes to let the energy storage capacitors completely discharged after disconnecting from power
source.
·The installation, service, recycling and disposal of the inverters must be performed by qualified personnel only in compliance
with national and local standards and regulations.
·Any unauthorized actions including modification of product functionality of any form may cause lethal hazard to the operator,
third parties, the units or their property. SAJ is not responsible for the loss and these warranty claims.
·The SAJ inverter must only be operated with PV generator. Do not connect any other source of energy to the SAJ inverter.
·Be sure that the PV generator and inverter are well grounded in order to protect properties and persons.
·The inverter will become hot during operation. Please do not touch the heat sink or peripheral surface during or shortly after
operation.
·Risk of damage due to improper modifications.
·The inverter is designed to feed AC power directly to the public utility power grid; do not connect AC output of the inverter to
any private AC equipment.
To Next Page
Loading...
Need help?
General
