What causes the E007 over-voltage at constant running speed error on my SAJ PDS23-4T011 Controller?
If you're seeing an E007 error on your SAJ Controller, which indicates over-voltage at constant running speed, it's likely caused by: * Abnormal input voltage: Install proper input AC reactor.
What to do if my SAJ Controller is overheating?
The SAJ Controller may overheat due to several reasons: * Instantaneous over-current: Refer to over-current remedy. * Output short circuit: Re-wire the output. * Cooling fan issues or ventilation obstruction: Replace the cooling fan and clear the ventilation channel. * High ambient temperature: Decrease the ambient temperature if possible. * Loose cables or terminals: Inspect and tighten the wires and terminals. * Abnormal power circuit: Ask for support.
What to do if SAJ PDS23-4T011 displays E010 controller overload?
If your SAJ Controller is showing an E010 error (Controller overload), it may be due to: * Too fast acceleration: Increase acceleration time. * Avoid prompt restart when trip-off.
What should I do if my SAJ Controller displays E009 under voltage of DC bus?
If your SAJ Controller shows error E009, which indicates under voltage of DC bus, it is likely due to: * Too-low input voltage: Check input power supply or wiring.
What causes the E011 motor overload error on my SAJ PDS23-4T011?
An E011 error on your SAJ Controller indicates a motor overload. This can happen due to: * Too-low input voltage: Check input power supply or wiring. * Lower-rating controller: Replace with higher-rating controller.
Why does my SAJ PDS23-4T011 display E005 over-voltage during acceleration?
The E005 error on your SAJ Controller, indicating over-voltage during acceleration, can be caused by: * Abnormal input voltage: Check input power. * Avoid prompt restart when trip-off.
What should I do if my SAJ PDS23-4T011 Controller shows E006 over-voltage during deceleration?
If your SAJ Controller is showing an E006 error (Over-voltage during deceleration), it may be due to: * Too-fast deceleration: Add proper braking units. * Abnormal input voltage: Check input power supply or wiring.
What causes E003 over-current during deceleration in my SAJ PDS23-4T011 Controller?
The E003 error on your SAJ Controller, indicating over-current during deceleration, may be caused by: * Too-fast deceleration: Increase deceleration time. * Too-heavy and large-inertia load: Add proper braking units. * Lower-rating controller: Replace with higher-rating controller.
Why does my SAJ PDS23-4T011 show E004 over-current at constant running speed?
If your SAJ Controller displays error E004, indicating over-current at constant running speed, there are several potential causes: * Sudden change of load: Check the load. * Too low input voltage: Check the input power supply or wiring. * Lower-rating controller: Replace with higher-rating controller.
What to do if SAJ Controller displays E002 over-current during acceleration?
If your SAJ Controller shows an E002 error (Over-current during acceleration), it could be due to: * Too fast acceleration: Increase acceleration time. * Too low input voltage: Check the input power supply or wiring. * Lower-rating controller: Replace with higher-rating controller.
General| Brand | SAJ |
|---|---|
| Model | PDS23-4T011 |
| Category | Controller |
| Language | English |
Essential safety guidelines for installation, operation, and maintenance procedures.
Explains the controller's built-in electronic monitoring and automatic shutdown mechanisms.
Outlines the necessary checks and procedures for the initial system startup.
Provides a comprehensive list of fault codes, their causes, and recommended remedies.
Discusses typical operational problems and their practical solutions for the controller.
To Next Page
