Sako SKI780 - Page 23

6.1 Brief introduction of function code
PO Standard Function Parameters
Function Parameter °
Code Nani Setting Range Default | Property
Acceleration/ eee frequency (PO-
P0-25 | Deceleration time 0 *
base frequency 1: Set frequency
2: 100 Hz
Base frequency for UP/ | ,.
P0-26 | DOWN modrfication | 2 Running frequency 0 *
d 1: Set frequency
uring running
Unit's digit (Binding
operation panel command
to frequency source)
0: No binding
1: Frequency source by
digital setting
2: All
3: Al2
4: Panel potentiometer
Binding command i
euet oe toltrequency 5: HDI Pulse setting (DI5) O99 *
6: Multi-command
7: Simple PLC
8: PID
9: Communication setting
Ten's digit (Binding terminal
command to frequency
source)
Hundred's digit (Binding
communication command
to frequency source)
17 \wwwsakohzcom