Sako SKI780 - Page 26

6.1 Brief introduction of function code
P2 Vector Control Parameters
Function Parameter 7
Code Nama Setting Range Default | Property
Digital setting of torque
P2-10 | upper limit in speed 0.0% ~ 200.0% 150.0% w
control mode
P2-13 Excitation adjustment 0~60000 2000 we
proportional gain
p2-14 Excitation adjustment 0~60000 1300 se
integral gain
pass | Trae adiusonent 0 ~ 60000 2000 | x
proportional gain
pag |,lomqueadiuetment 0 ~ 60000 1300 |r
integral gain
Unit's digit: integral
5 Speed loop integral separation
Baht property 0: Disabled 0 *
1: Enabled
p2.29 | Maximum output voltage | 19994 ~ 110% 105% |
coefficient
Maximum torque
P2-21 | coefficient in weak 50% ~ 200% 100% D4
magnetic field
www sakohzcom/ 20