Salda SMARTY XP

To Next Page

To Previous Page

EN | 47SMARTY v2023.1

Figure 8.15.11. Smarty 3X V / 4X V F2 1.1 (219.1349.0.1.2-PS) Figure 8.15.12. Smarty 3X V / 4X V F2 1.1 (219.1349.0.1.3-PS)

Main Page

Table of Contents2
Symbols and Marking4
Safety Instructions and Precautions5
Information about the Product6
Description6
Dimensions and Weight7
Technical Data10
Operating Conditions11
Standard Package of Components11
Description of Components12
Installation13
Reception of Goods13
Transportation and Storage13
Unpacking13
Piping and Instrumentation Diagram14
Mounting16
Unit Placing and Mounting Positioning Requirements17
Ceiling-Mounting of the Unit (Smarty Xp)18
Floor Mounting (Smarty XV)18
Wall-Mounting of the Unit (Smarty XV)18
Drainage (Smarty XV)19
Connection of the Air Duct19
Connection of the Unit to Electric Network21
Start-Up Recommendations21
System Protection21
Pre-Startup Recommendations of the Unit (in the Presence of the End-User)21
Maintenance22
Safety Instruction22
General Recommendations for the Maintenance of Ventilation System22
Cover Opening22
Filters Maintenance23
Heat Exchanger Maintenance23
Fan Maintenance24
Bypass Dampers and Pre-Heater (Version 1.1) Maintenance26
Control Board Maintenance28
Control30
Device Control30
Device Functions30
Connection of Accessories31
Heater and Pre-Heater31
Version33
Version S30036
Heater36
Preheater36
Fire Protection Signal Input (Fire Protection Input (Nc)) (Version 1.1 / 1.2)37
Fire Protection Signal Input (Version S300)37
External Co /Rh Sensors (Version 1.1 / 1.2)38
Room Co Transmitter Installation Recommendation38
Co Concentration According to Pettenkofer Limit39
Connection of Supply and Exhaust Air Dampers (Version 1.1 / 1.2)39
Outside Air Dampers (Version S300)39
Connection of Remote Control Panel, Knx Room Sensors and Modbus (Version S300)39
Connection of Remote Control Panel or Modbus (Version 1.1 / 1.2)40
Fireplace Protection/System Mode Swith/Rapid Ventilation Switch Input (Version S300)40
Operation Indication Output (Version S300)41
Alarm Indication Output (Version S300)41
Fire Place Protection (Version 1.1)41
Recommended Schemes for Connection of Internal and External Components42
Connection to Wiring Terminals (Version S300)49
Accessories Setup (Version S300)50
Access of Configuration Parameters50
Heater51
Preheater51
Smoke Detector51
Fireplace Protection, System Mode Switch or Rapid Ventilation Switch Input51
Alarm Indication Output52
Remote Controller and Knx Room Sensors52
Operating the Unit52
Possible Faults and Troubleshooting52
Ecodesign Data Table53
Declaration of Conformity58
Warranty59
Limited Warranty Coupon59

Salda SMARTY XP - Page 47

Table of Contents

Related product manuals