Salda SMARTY XP - Bypass Dampers and Pre-Heater (Version 1.1) Maintenance

26 | EN SMARTY v2023.1
Figure 6.6.7. Smarty 2X P
NOTE. Prior to performing steps in Figure 6.6.7, steps in Figure 6.3.1 (1-3) and Figure 6.5.1 (1-4) / Figure 6.5.2 (1-2) should be carried out.
Figure 6.6.8. Smarty 3X P / 4X P
NOTE. Prior to performing step in Figure 6.6.8, steps in Figure 6.3.2 and Figure 6.5.4 (1-3) should be carried out.
Figure 6.6.9. Smarty 2X V Figure 6.6.10. Smarty 3X V / 4X V
6.7. BYPASS DAMPERS AND PRE-HEATER (VERSION 1.1) MAINTENANCE
• Bypass damper must be disconnected from control board (connections X3 and X5 (version 1.1 / 1.2); connection X4 (version S300)).
• When removing the damper, steps in Figure 6.3.1 (1-3), Figure 6.5.1 or Figure 6.5.2 (1-3), Figure 6.6.7 (1-3) should be performed for Smarty 2X P,
and steps in Figure 6.3.2, Figure 6.5.3 or Figure 6.5.4 (1-3), Figure 6.6.8 (1-2) for Smarty 3-4X P.
• +DYLQJUHPRYHGWKHGDPSHUORRVHQWKHVFUHZVXSSRUWLQJOXJV'LVFRQQHFWFRQWDFWVIURPWKHUHDUVZLWFK
• 5HPRYHVHDODQWZLWKWKHZLUHVDQGFRQQHFWLRQV
• 5HPRYHWKHVFUHZV
• 5HPRYHWKHGULYHZLWKDOOWKHZLUHV
• 5HDVVHPEOLQJPXVWEHH[HFXWHGLQWKHUHYHUVHRUGHULQVHUWWKHZLUHVZLWKDUHDUVZLWFKFRQQHFWLRQWKURXJKDKROHLQVWDOOEDFNWKHVHDODQW
LQVHUWWKHGULYHOXJLQWRWKHGDPSHUD[LVWKHPLOOHGSODWHRIWKHGULYHOXJPXVWEHSDUDOOHOWRWKHGDPSHUD[LVSODWHZKHUHWKHWLJKWHQLQJVFUHZ
hole is located).