Salora 19LED7010TW - 2) 3.AM Search and Upgrade Mode; Appendix C: Supported DVI Resolutions; Appendix D: Software Upgrade; Software Upgrade Search Via User Interface

English - 60 -
Appendix C: Supported DVI
Resolutions
When connecting devices to your TV’s connectors by
using DVI to HDMI cables (not supplied), you can refer
to the following resolution information.
Index
Resolution
Frequency
1
640x400
70Hz
2
640x480
60Hz-66Hz-72Hz
-75Hz
3
800x600
56Hz-60Hz-70Hz-
72Hz -75Hz
4
832x624
75 Hz
5
1024x768
60Hz-66Hz-70Hz-
72Hz -75Hz
6
1152x864
60Hz-70Hz-75Hz
7
1152x870
75Hz
8
1280x768
60 Hz
9
1280x768
75Hz
10
1280x960
60Hz-75Hz
11
1280x1024
60Hz-75Hz
12
1360x768
60 Hz
13
1400x1050
60 Hz
14
1400x1050
75Hz
15
1400x900
65Hz-75Hz
16
1600x1200
60 Hz
17
1680x1050
60 Hz
18
1920x1080
60 Hz
19
1920x1200
60Hz
20
480i-480p
60Hz
21
576i-576p
50Hz
Appendix D: Software Upgrade
Your TV is capable of nding and updating new •
software upgrades over broadcast channels.
For broadcast channels search, the TV looks at the •
available channels stored in your settings. So before
the software upgrade search, it is advised to auto
search and update all available channels.
1) Software upgrade search via user
interface
It is possible to manually to check if there is a new •
software upgrade for your TV set.
Simply navigate on your main menu. Choose •
Settings and select Other Settings menu. In Other
Settings menu navigate on to the Software Upgrade
item and press OK button to open Upgrade Options
menu.
In Upgrade Options menu select Scan for upgrade •
and press OK button.
If a new upgrade is found, it starts to download the •
upgrade. A progress bar indicates the remaining
download progress. When the download completes
successfully a message is displayed for reboot to
activate new software. Press OK to continue with
the reboot operation.
2) 3.AM search and upgrade mode
If Automatic scanning in Upgrade Options menu is •
enabled, the TV wakes up at 03:00 and searches
the broadcast channels for new software upgrade. If
new software is found and downloaded successfully,
with the next power up the TV opens with new
software version.
Note on reboot operation: Reboot is the last step
in software upgrade operation if download of new
software is nished successfully. During reboot TV
makes nal initializations. In the reboot sequence
panel power is closed and front led indicates the
activity with blinking. Around 5 minutes later TV
restarts with new software activated.
If your TV fails to restart in 10 minutes, unplug power •
for 10 minutes and re-plug again. TV should open
with new software safely. If you still can not get
TV working, please kindly repeat unplug and plug
sequence a few times more. If your set still can not
operate, please call the service personnel to x the
problem for you.
Caution: While the LED is blinking during reboot do
not unplug your TV’s power. Doing this may cause
your TV not to re-start again and can only be xed
by service personnel.