EasyManua.ls Logo

Salus iT600 Series User Manual

Salus iT600 Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Dial Thermostat
Models: VS05
INSTALLER / USER MANUAL
iT600 VS05 Installer - User Manual_Layout 1 06/06/2014 10:03 Page 1
All manuals and user guides at all-guides.com
all-guides.com
Question and Answer IconNeed help?

Do you have a question about the Salus iT600 Series and is the answer not in the manual?

Salus iT600 Series Specifications

General IconGeneral
TypeSmart Thermostat
MountingWall-mounted
ConnectivityZigBee
Control MethodApp
DisplayLCD
ProgrammableYes
Energy MonitoringYes

Summary

Product Compliance & Safety Information

Introduction

Welcomes user and introduces the SALUS VS05 dial thermostat for heating systems.

Product Compliance

States the product meets CE standards and relevant EC Directives for electromagnetic compatibility and low voltage.

Safety and Installation Guidelines

Covers safe usage, professional installation requirements, potential dangers, and emergency procedures.

Installation – Thermostat Mounting

Mounting Position and Installation Advice

Advises on optimal placement in draft-free areas at 130cm, avoiding heat sources and direct sunlight.

System Overview, Grouping and Communication

System Components and Communication

Explains power/switching cables, grouping/communication cables, and thermostat communication with VS10 master.

Introduction to System Options

System Grouping Configurations

Illustrates system options for two groups (e.g., down/upstairs) using SALUS KL10 wiring centre.

Installation – Terminal Connections

Terminal Identification and Function

Details power, sensor, and communication terminals on the VS05 rear and their functions.

Wiring and Connection Guide

Provides a visual guide for connecting the thermostat, including optional communication connections.

Final Installation Checks

Instructions to check wiring, use provided screws, and ensure correct orientation before mounting.

Installation – Parameter Setting

Floor Sensor and Dip Switch Settings

Explains setting optional floor sensor temperature and dip switch configurations for air/floor.

Installer Parameter Functions

Details installer settings for Valve Exercising, PWM, PROBE, Actuator, and Setback functions.

User Interface

Controls and Indicators Overview

Describes the dial for temperature adjustment, LED indicators, and the mode selection switch.

LED Indication when Following Group Master

Normal Operation and Temperature Drop

Red LED indicates power; top LED illuminates when room temperature falls below the required setpoint.

Reduced/Night Mode Status

No LED in reduced mode; amber LED indicates calling for heat in reduced/night time mode.

Frost Protection Status

Blue LED indicates frost protection mode; green LED indicates calling for heat during frost protection.

LED Indication in Manual Mode

Standalone Operation Indicators

Red LED for power/temp drop; green LED for calling for heat when used as a standalone thermostat.

Specifications

Technical Specifications Summary

Details model, type, temperature, control, environment ratings, power source, and agency approvals.

Warranty Information

Product Warranty Terms

Outlines the two-year warranty period, conditions, and liability for defects.

Related product manuals