Salus RT310RF User Manual

18
6. Installer mode
To enter installer parameters please follow steps below. Please refer to parameters table description before any changes. Use button to move through
parameters. Use or for adjustements. Every change/selection conrm by button.
DETAILED TABLE WITH ALL INSTALLER PARAMETERS:
Press and hold
+ +
simultanously for about 3 seconds to
enter the installer mode.
Use button to move through
parameters. Use or for
adjustements. Every change/selection
conrm by button.
1 2
3 sec
3 sec
3 sec
dxx Function Parameter
Default
value
d01 Temperature display accuracy 0.1°C or 0.5°C 0.5°C
d02 Temperature oset +/- 3.0°C 0.0°C
d03 Frost Protection setpoint temperature 5.0°C - 17.0°C 5.0°C
6.1 DIP switches parameters
DIP switches are used to set chosen control algorithm. They are located under back cover of the thermostat (please refer to the picture below):
The position of the DIP switches determines the type of control algorithm:
PLEASE NOTE! TPI algorithm is recommended for underoor heating. It can be adjusted between a low comfort level (6 CPH) and a higher
comfort level (9 CPH). „CPH” means cycles per hour and it relates to the frequency of the measurement cycles performed by thermostat.
9CPH ±0.25°C
6CPH
Span
TPI
ON
1 2
1 2 Cooling * Heating Default value
ON ON Hysteresis +/- 0.25 Hysteresis +/- 0.25
OFF ON Hysteresis +/- 1.5 Hysteresis +/- 0.5
ON OFF Hysteresis +/- 1.0 TPI 9 CPH
OFF OFF
Hysteresis
+/- 0.5
TPI 6 CPH
* Function available only from rmware version 2.1

Salus RT310RF Specifications

General

Type	Wireless thermostat
Frequency	868 MHz
Temperature Range	5°C to 35°C
Power Supply	2 x AA batteries
Display	LCD
Mounting	Wall-mounted
Programmable	Yes
Frost Protection	Yes
Holiday Mode	Yes
Control Mode	Manual
Communication	RF (Radio Frequency)
Range	Up to 30 meters (open space)
Compatibility	Boilers
Dimensions	120mm