Salus RT500RF - Frost Protection Mode; Reviewing Set Point Temperature

RT500RF INSTRUCTION MANUAL
21
FROST PROTECTION
To enable the Frost Protection mode, press and hold the BACKLIGHT / FROST
button for three seconds with the RT500RF in Normal mode. Once Frost
Protection is enabled, the set point temperature is automatically set to 5°C
to provide protection from the risk of freezing.
Whenever Frost Protection is activated, the Frost Protection indicator will
flash in the sequence shown below:
While Frost Protection is activated, it will override any programme settings
until the mode is changed. To turn off Frost Protection mode, press and hold
the BACKLIGHT / FROST button for three seconds.
REVIEWING SET POINT TEMPERATURE
You can view the set point temperature at any time by pressing either the UP
or DOWN key.
When any programme is running, the LCD
display will show the programme set point
temperature with the SET indicator
displayed:
Salus RT500RF Manual:89 9/7/10 10:10 Page 21