SaMASZ KDT 260 User Manual

15
OPERATOR’S MANUAL
DISC MOWER
KDT
Fig. 6. Location of centre of gravity
Tab. 4. Location of centre of gravity
Dimension
[mm]
[ft. in]
Model
KDT 180
KDT 220
KDT 220
S
KDT 220
W
KDT 260
KDT 260
S
KDT
260 SL
KDT 260
W
KDT 300
KDT 340
KDT 341
A
730
2′ 5″
715
2′ 4″
835
2′ 9″
850
2′ 9″
815
2′ 8″
825
2′ 8″
810
2′ 8″
840
2′ 9″
710
2′ 4″
715
2′ 4″
B
130
5″
25
1″
105
4″
140
5.5″
160
6.3″
200
8″
220
8.7″
220
8.7″
310
1′
490
1′ 7″
C
840
2′ 9″
970
3′ 2″
1010
3′ 4″
1060
3′ 6″
1010
3′ 4″
1030
3′ 5″
1020
3′ 4″
1080
3′ 7″
1045
3′ 5″
1100
3′7″
4.5. Working parts
❑ Before operating the mower check knife’s and knife mounting’s condition.
❑ Worn or damaged knives or knife mounting should be immediately replaced with new one.
WARNING!
During replacement of working parts, it should be used personal protective
gloves.
4.6. PTO shaft
❑ Before operating learn provisions found in bar manufacturer's manual placed on the bar.
❑ Use only PTO shafts recommended by mower’s manufacturer with guards in good condition.
❑ In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO shaft
shall be repaired or replaced with new one.
❑ Before any operation make sure whether PTO rpm have proper rotational direction.
4.7. Hydraulic assembly
❑ Caution! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate through
skin and cause serious injury, therefore skin and eyes should be protected in particular. In case of
injuries caused by a liquid under pressure, call a doctor immediately.

SaMASZ KDT 260 Specifications

General

Brand	SaMASZ
Model	KDT 260
Category	Farm Equipment
Language	English