6.11.3. Daily maintenance
Everyday after work please carry out the following maintenance:
❑ clean the mower each day after working, especially between discs and the cutterbar, because grass
with mud may damage bearings in the disc module,
❑ remove grass and mud, also from under the covers of the belt transmission of the conditioner /
rollers,
❑ check all visible units and parts and their connections; tighten all loose bolts and nuts and replace
all damaged and/or worn parts with new genuine ones,
❑ check the cutterbar,
❑ grease PTO shaft tubes with STP grease,
❑ if necessary, lubricate the parts and units according to lubrication instructions (chapter 7).
Parts, which may cause risk to operator’s health and safety are as follows: damaged disks,
tarpaulin covers, worn or damaged hydraulic hoses, PTO shaft guides, worn knives and knife mounting
pins.
To Next Page
Loading...
Need help?
General
