9. DISASSEMBLY AND WITHDRAWAL FROM USE
9.1. Disassembly
WARNING!
Before disassembly the mower should be disconnected from the tractor.
Before starting any repair or service the mower should be cleaned and any grass or dirt removed.
Carefully check nuts and bolts for adequate torque and the pins for wear. Replace screws, v-belts,
pins, bushings, discs, knives, holders, mountings, etc. if necessary.
Once the machine is repaired perform the following:
❑ Make sure that all elements are installed properly,
❑ Install the removed guards,
❑ Check that all screws and nuts are tightened,
❑ Check for proper clearance on pins and gears,
❑ Once all the guards are installed, perform a warm-up start to make sure the repaired machine
operates properly.
9.2. Scrapping
If the mower cannot be repaired anymore, it should be withdrawn from use.
For this purpose oil from intersecting axis gear and cutterbar should be drained and delivered to
a proper waste treatment company. Clean the mower parts, dismantle and dispose properly of all plastic
parts. After that, the mower could be sold to breaker’s yard.
WARNING!
When disassembling the machine pay particular attention to additional dangers
as crushing, cutting, wounding, concussion. Use proper tools and personal
protective equipment: protective gloves, clothing and shoes, goggles, etc. Pay
attention so that the machine works efficiently, and therefore it is required to
secure the machine with supports.
10. WARRANTY CARD
REAR DISC MOWER
The product quality has been checked and meets the required standards and regulations and is
permitted for use.
To Next Page
Loading...
Need help?
General
