SAMES KREMLIN Cyclomix Micro

Questions and Answers

A
Amber KirbyAug 2, 2025
What to do if the mixing ratio is incorrect with my SAMES KREMLIN Mixer?
- C
  cmckeeAug 2, 2025
  If the mixing ratio is incorrect, check the pressure differential. The catalyst (CATA) pressure must be higher than the base (BASE) pressure by 15%.
J
Joseph KelleyAug 7, 2025
What to do if there is no signal from the flow-switch in my SAMES KREMLIN Cyclomix Micro Mixer?
- G
  gambleloriAug 7, 2025
  If there is no signal from the flow-switch while there are impulses on the base flowmeter or the catalyst flowmeter, check the operation of the flow-switch and replace it if necessary. Also, control the operation of the electronic card and increase the value of P12.
A
Amanda MccarthyAug 12, 2025
What to do if time between air opening and fluid opening is too long in SAMES KREMLIN Mixer?
- D
  Dr. Todd Garcia DVMAug 12, 2025
  If the time between air opening and fluid opening is longer than 6 seconds, and the flow switch is blocked or there is an air leak, trigger the gun quicker or change the flow switch.
B
Beverly WallaceAug 17, 2025
What to do if the VP6 valve is leaking in my SAMES KREMLIN Cyclomix Micro?
- D
  dmurphyAug 17, 2025
  If the VP6 valve is leaking, remove the VP6 valve and check its correct operation. If necessary, change the valve.
C
Carrie AlexanderAug 22, 2025
How to fix a blocked BASE flowmeter in SAMES KREMLIN Mixer?
- B
  Bonnie Robbins DVMAug 22, 2025
  To fix a blocked BASE flowmeter, check the fluid circuit, including the pump and valve. Clean or change them as necessary. Also, check or install a filter upstream of the flowmeter.
M
Melissa AguirreAug 28, 2025
How to fix a blocked CATA flowmeter in SAMES KREMLIN Mixer?
- M
  Michael McdonaldAug 28, 2025
  To fix a blocked CATA flowmeter, check the fluid circuit, including the pump and valve. Clean or change them as necessary. Also, check or install a filter upstream of the flowmeter.