SAMES KREMLIN Inogun M - Health and safety instructions; Configuration of the certified equipment; Applicable Standards

Index revision : C - July 2021 5 7132
1. Health and safety instructions
This manual contains links to the following operating instructions:
• see RT Nr 7145
for the Inobox control module.
• see RT Nr 7134
for the Inocontroller control module.
1.1. Configuration of the certified equipment
All of these operating manuals define the configuration of the certified equipment.
1.2. Applicable Standards
The "Inogun M" gun has been designed according to standards indicated below:
Applicable Requirements:
•
CAN/CSA C22.2 No. 0-10 : General Requirements - Canadian Electrical Code,
Part II
• CAN/CSA-C22.2 No. 60079-0:19: Explosive Atmospheres - Part 0: Equipment - Gen-
eral requirements
• CAN/CSA-C22.2 No. 60079-7:16: Explosive Atmospheres – Part 7: Equipment pro-
tection by increased safety “e”
• CAN/CSA-C22.2 No. 60079-11:14: Explosive Atmospheres – Part 11: Equipment
protection by intrinsic safety "i"
• CAN/CSA C22.2 No. 61010-1-12: Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use - Part 1: General Requirements - Third
Edition
• ANSI/ISA-61010-1 3
rd
Edition: Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use - Part 1: General Requirements - Third
Edition
• ANSI/UL 60079-0:2019: Electrical Apparatus for Explosive Gas Atmospheres - Part 0:
General Requirements
• ANSI/UL 60079-7: 2017: Explosive atmospheres - Part 7: Equipment protection by
increased safety "e"
• ANSI/UL 60079-11:2013: Electrical apparatus for Explosive Gas Atmospheres - Part
11: Intrinsic Safety “i”
As a guide:
•
FM 7260: 1996: Approval for Electrostatic Finishing Equipment
• FM3600: 2018: Electrical Equipment for use in Hazardous (Classified) Locations
General Requirements
• CSA TIL No. 320: 1991 Electrostatic Paint Sprayers
Installation:
• In Canada, the installation has to be in compliance with the Canadian Electrical Code
C22.1 part I, standard safety for electrical installations.
• In the USA, the installation has to be in compliance with the National Electrical Code NFPA
70.