2.3 Attachment to Type 3510
Micro-flow Valve
The positioner is attached to the valve yoke
using a bracket.
Refer to Table 3 on page 11 for the required
mounting parts as well as the accessories
with their order numbers.
Note the travel table on page 9!
1. Place clamp (3) on the valve stem con
-
nector, align at a right angle and screw
tight.
2. Screw bracket (10) to the valve yoke us-
ing two screws (11).
3. Mount connecting plate (6) or pressure
gauge bracket (7) with pressure gauges
to the positioner, making sure both seal
rings (6.1) are seated properly.
4. Unscrew the standard installed lever M
(1) including follower pin (2) from the
positioner shaft.
5. Take lever S (1) and screw follower pin
(2) in the bore for pin position 17.
6. Place lever S on the positioner shaft and
screw tight using the disk spring (1.2)
and nut (1.1).
Move lever once all the way as far as it
will go in both directions.
7. Place positioner on the bracket (10) in
such a manner that the follower pin
slides into the groove of the clamp (3).
Adjust the lever (1) correspondingly.
Screw the positioner to the bracket (10)
using both its hexagon screws.
18 EB 8384-1 EN
Attachment to the control valve – mounting parts and accessories
To Next Page
Loading...
