Owner’s Manual
7
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANOPOLSKI
1. Power/Pair Switch - Press less
than 5 seconds to turn the unit
on or off. Press and hold for
more than 5 seconds to enter
pairing mode.
Note: The Go Mic Mobile
receiver and transmitter are pre-
paired from the factory.
2. Analog Output Select Switch - Sets
the wiring of the analog output.
The OUT 1 & 2 positions are for
connecting to a smartphone’s
TRRS headset input. The
Headphone/Line output is for
connecting the receiver to a
camera, mixer or headphones.
3. VOL Control - This slider sets the
level of the audio signal sent to the receiver’s digital and analog outputs.
4. MIX / 2 CH Switch - Sets the receiver audio output to either mixed mono or split
left and right.
5. CH 1 & CH 2 Indicators - When lit white, the LEDs indicate the receiver is paired
with a transmitter. When the transmitter input or the receiver output is clipped,
the LEDs flash red.
6. Battery Level Indicator - This indicator lights green when the battery is charged,
lights red when the battery is low, and orange when the battery is charging.
7. Power Indicator - This indicator lights green when the Go Mic Mobile Receiver is
powered on.
8. USB AUDIO Output - Use this output when connecting to a digital audio input.
9. OUT Jack - Use this 3.5mm jack when connecting to an analog input or
headphones.
10. USB CHARGE Port - Use this Mini USB jack to connect the Go Mic Mobile
Receiver to the included AC adapter to charge the receiver’s internal battery.
11. Lock Screw - Turn left to loosen the screw and adjust the mounting arm. Turn
right to lock the mounting arm in place.
Go Mic Mobile Receiver (GMM) Callouts
10
1
3
4
2
5
6
9
8
11
7
To Next Page
Loading...
