Samsung 6100 Series - Auto Program Setup

tnr•~·~•
"
=-
·
·
;;i
~
When
Network Settings
is
complete, your
1V
will
check for a new
software version automatically.
If
new software
is
available, the
1V
downloads and installs
the new software. When the download is
complete, select
Next.
~
If
you want to upgrade later, select
Skip.
For more information, refer
to
Software
Update
(Preference Features
->
Support
Menu) in the
e-Manual.
~
This may take some time, depending
on
your network status.
~
You
can
only
upgrade software if your
TV
has an active network
connection.
~
If
no new update software
is
available, a no new updates message
appears on the screen.
Select
OK.
The
Terms
of
Service Agreement
screen appears.
~
The screen can take a few seconds
to
display.
The
General Disclaimer
screen appears.
Select
Agree.
The
Privacy
Policy
screen appears. Select
Agree.
~
To
use
Smart Hub,
you must select
Agree
for the
Terms of Service
Agreement.
Select the appropriate option for your
1V
using your remote, and then
select
Next.
• I
use an antenna cable connection
to
the
TV.:
Select
if you have an
antenna or a cable connection without a set-top box.
If
you select this
option,
go
to
7-
Auto Program
(2)
Step.
• I
use a set-top box.:
Select
if you have a
satellite
or cable
set-top
box.
You
do
not need
to
run
Auto Program.
If you select this option,
go
to
9 -
Clock
on the next page.
1.
Select
Air
or
Cable
using your remote. A check appears on your
selection. When done, select
Next.
You
can check both if you have
both
co
nnected.
2.
If
you selected
Air,
go
to
8 -
Auto Program
(3).
3.
If
you selected
Cable,
you'll
go
to the cable system screen.
Select
Digital Cable
System.
The option
window
appears.
Select
the
correct
cable signal
format;
STD.
HRC,
or IRC.
Most
cable
systems
use
STD
(Standard). Repeat the same process with
Analog
Cable
System.
4.
When done,
select
Next.