Configuring Network Connections
After you have
run
the initial setup, you can configure
or
reconfigure the network connections through the
TV's menu.
Configuring a Wireless Network Connection
The instructions below are for networks that use the Dynamic Host Configuration Protocol (DHCP)
to
configure network connections automatically. Most wireless networks use DHCP.
If
you have a Static
IP
network, see the e-Manual for configuration instructions.
To
configure the network connection for a network that uses
DHCP,
follow these steps:
1. Connect your TV to your network as shown
in
the illustration
on
page 15.
2. Turn on your
TV,
and then
go
to the Network Settings screen. (Menu
----->
Network
----->
Network
Settings)
3. Select Start. The Network function searches for available wireless networks. When done, it displays a
list
of
the available networks.
4.
In
the list
of
networks, move the highlight
to
select a network, and then select Next.
~
If you have a WPS(PBC) compatible route
r,
select WPS(PBC) instead, and then follow the
directions on the screen.
5. Enter your network security key
or
WPS PIN using your remote.
~
Enter numbers and letters using your remote.
• Enter numbers
by
pressing the number buttons on your remote.
•
To
enter a letter, move the Highlight
to
the letter, and then select it.
You
can enter numbers
in
the same fashion if you choose.
~
To
display capital letters (or redisplay small letters if capital letters are displayed), select Caps or
Shift.
~
To
display symbols and punctuation,
select*·
To
redisplay letters,
select*
again.
6. When done, select Next if you have entered a security key
or
WPS PIN if you have entered a WPS PIN.
7. The TV checks the wireless connection. If the connection
is
successful, the
"You
are connected to the
Internet. If you have any problems using online services, please contact your Internet Service
Provider." message appears. Select Next using your remote.
~
For more detailed information, see "Setting up the Wireless
Netw
ork"
in
the e-Manual.
~
If you want to configure the connection manually, select IP Settings on the Network Conne
ct
ion
screen. Set IP
Mode
to Manual, and then enter the
IP
Address, Subnet
Mask
, Gateway, and
DNS
Server manually.
To Next Page
Loading...
