Samsung AEGIS WF8500NHW - Page 18

Removal and Reassembly _ 19
Part Figure Description
COVER-BACK
• Removethe4screwsholdingtheBack-
Coveratthebackofthewashingmachine.
BELT
1. Separatethebeltandthenassemblyit.
2. Checkifthebeltpositionisatthecenterof
thePulley.
 Assemblingthebelt
 PlacethebeltaroundthePulley( )
andthenovertheMotor-Pulley( ).
MOTOR
1. SeparatetheWireHousingfromthemotor.
2. Removethetwoboltsholdingthemotorat
thebackofthewashingmachine.
The2screwsdesignated‘A’whichare
insidemustbealsoremoved.
3. Separatethemotor.
 WheninstallingtheBeltaroundtheMotor
Pulley,thebottomofthebeltmustbe
locatedonthesecondooroftheMotor
Pulley.
A
WF-M592NMH-YLP.indb 19 2010-2-22 13:29:45