EasyManua.ls Logo

Samsung DCS - CALL PARK AND PAGE; SETTING A MESSAGE INDICATION

Samsung DCS
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CALL PARK AND PAGE
When you have an outside call for someone who is not at his/her desk,
you can park the call and page the requested party:
• While in conversation, hookflash and dial 5 5 . The call is automat-
ically parked at your station.
• Dial the desired page zone and make an announcement. Be sure
to include your station number, example, “Mr. Saint, park 201.”
RETRIEVING A PARKED CALL
To retrieve a call that has been parked for you:
• Lift the handset.
• Dial 1 0 plus the station number that was announced. You will be
connected to the parked call.
SETTING A MESSAGE INDICATION
When you are calling another station and no one answers or you re c e i v e
a busy signal, you can set a message indication at that station. The M E S -
S A G E key on keysets will flash and standard telephones will re c e i v e
special dial tone.
• Hookflash and dial 4 3 .
• Receive confirmation tone and hang up.
If the keyset you are calling is in the Auto Answer mode , you must use
the following pro c e d u re :
• Hang up for at least two seconds.
• Lift the handset.
• Dial 4 1 plus the extension number.
• Receive confirmation tone and then hang up.
NOTE: Astation can have up to and including five message indications.
If you receive dial tone instead of confirmation tone, there are
a l ready five messages at this station. Try again later.
18
SLT 99.1.20 3:29 PM ‰¿Ã¡ˆ21

Table of Contents

Other manuals for Samsung DCS

Related product manuals