Samsung Electronics
4-17
Installation
12. You should leave spacing around the outdoor
unit at least according to the figure for easy
installation, service and ventilation.
13. Install the outdoor unit on a rigid base.
14. Fasten the outdoor unit to the base by using
bolts or nuts.
15. In case of hanging the outdoor unit, you should
hang it on a rigid wall area and use right angle
steel thickness of 4 mm. as a holder.
Caution :
It is harmful to the air conditioner if it is used in the following
environments: greasy areas (including near machines), salty
areas such as coast areas, areas where sulfuric gas is present
such as hot spring areas, large variance in electricity voltage
such as in a factory. Contact your dealer for advice.
0.1 m.
0.1 m.
0.35 m.
Rigid wall
Right angle steel thickness of 4 mm.
Fasten right angle steel by using screws
Duct-ADH1800E-2-1 4/12/00 5:44 PM Page 4-17
To Next Page
Loading...
