• Wired Remote Controller - Buttons and Display
2-6
Samsung Electronics
Product Specifications
The wired remote controller is an optional accessory.
Note : - Test button is for your installation specialist. You must NOT press it.
- After cleaning the air filter, press the filter reset button, if the filter has been installed.
Then the wired remote controller will display the FILTER SIGN indicator when the time to
clean the air filter; refer to page 30.
Communication error indicator
On Timer setting
Off Timer setting
Test indicator
On Timer button
Off Timer button
Test button
Filter Reset button
Mode selection button
Temperature adjustment
buttons
Removing frost indicator Centralized controller indicator
(In case of installing the Centralized controller)
Temperature setting
Fan speed
Filter Sign indicator
On/Off & Timer
Set/Cancel button
Fan speed
adjustment button
On/Off indicator
Operating mode
The wired remote controller is installed on the wall.
Duct-ADH1800E-1 6/27/00 10:36 AM Page 2-6
To Next Page
Loading...
