Samsung DIGIMAX 300 - Starting the SETUP mode; Power off

SETUP
59
Starting the SETUP mode
This function switches the camera off after a set amount of time in order to prevent unnecessary
battery drainage.
You can set the power to switch off at any specified time( 1 ~ 10MIN, 1MIN interval) from the
last operation.
If you select [CANCEL], the power off function will not operate.
Note that the automatic power off does not operate if the camera is in slide show or playing a
movie clip.
1. Select the SETUP mode by rotating the mode dial.
2. [SETUP 1/2] menu will be displayed.
3. Press the UP (
)/ DOWN ( ) button and select
[POWER OFF].
4. Press the SET( ) button and the sub menu will be
displayed.
5. Select the desired sub menu by pressing the
UP( )/ DOWN ( ) button. Press the SET( )
button to confirm the setting.
6. The default is [1 MIN].
SETUP 1/2
POWER OFF
10 MIN
EXIT:MENU SET:
SETUP 1/2
BEEP ON
POWER OFF 10 MIN
DATE IMPRINT ON
DATE TYPE YMD
CHANGE:
Even if the batteries or AC adapter are removed and inserted again, the power off setting
will be preserved.
INFORMATION
Power off