149
- This Document can not be used without Samsung's authorization -
. SERVICE INFORMATION
1. Do the disassembling and assembling camera where the blocking static electricity mat is on the table.
2. When handling the major PCBs of camera, please wearing the band which cuts off the electric current on
the wrist.
3. When handling the major parts, be careful of below caution.
1. Caution
Parts Caution
F PCB type
CCD CCD
& IR CUT
PCB type
CONTACT type
When assembling the F PCB to the CONNECTOR by using pincette, be
careful of tearing and hooking.
Be careful of the handprinting while handling them.
Using the pincette which has soft tip.
The spot will be shown by using normal alchol when cleaning them.
Do the repairing where is no dust.
Wearing the band which cuts off the electric current and do the reparing
Where the blocking static electricity mat is on by preventing the defect of parts.
Be careful of defect and change by pincette.
To Next Page
Loading...
